Detailed Explanation Of The Crimping Steps Of Bolt-type Tension Clamps

1. Unpack and inspect materials
2. Appearance inspection and cleaning
① Check the specifications, appearance and size of the bolted type strain clamp model.
Ensure that the length, outer diameter and inner diameter of the pipe meet the requirements, and the thickness is uniform and meets the requirements;
② Use a cotton ball soaked in alcohol to clean the oil stains on the inner wall of the pipe,
and remove the zinc scars and welding slag that affect the penetration of the pipe.
▲ Clean the steel anchor
▲ Clean the aluminum tube
3. Pipe and crimp the steel core aluminum stranded wire steel pipe
① Peel off a section of the wire to expose the steel core
The cutting length of the steel core is: steel pipe length + 15mm
▲ Peel off the steel core
② Pre-insert the aluminum tube first,
then insert the steel core into the steel anchor,
and press 1~5 in sequence with a hydraulic press.
▲ Steel core crimping sequence
4. Aluminum tube marking and crimping
① After marking,
rotate the aluminum tube along the direction of aluminum stranding and push it toward the steel anchor side.
▲ Aluminum tube marking
② The aluminum tube that has been pressed on the steel tube is not crimped,
The rest of the aluminum tube is crimped in the order of 1 to 6;
▲ Aluminum tube crimping sequence
5. Measurement and verification
▲ Crimping
▲ Wire clamp crimping
▲ Tension wire clamp crimping
Standard crimping completed
▲ dead end strain clamp crimped
bolted dead end clamp crimped will be painted red at the beginning and end,