Things To Note When Using Iot Remote Smart Meters

4. If the user card is lost, the corresponding card replacement procedures must be carried out at the management terminal.

Precautions for using IoT remote 3 phase energy meter wifi:

1. Since the energy meter 3 phase wifi is composed of precision electronic components and uses wireless communication, it should be installed away from heat sources, strong corrosion, and strong radiation areas when smart energy meter 3 phase is installed.

2. Metal objects have a shielding effect on wireless signals and may even cause communication failure. Therefore, when installing wifi smart energy meter 3 phase with Nb module, it should be kept away from closed metal environments as much as possible, or slots should be made on the metal structure so that smart energy meter wifi wireless signals can pass.

3. The power/control interface and motor interface must be connected correctly, otherwise three phase smart energy meter will be damaged.

4. After wiring, check whether the power/control interface is short-circuited, and power on only after confirming that there is no abnormality.

5. The installed electronic module components need to be treated with moisture-proof treatment. The components on the circuit board are precision devices, and attention should be paid to electrostatic protection when installing single phase smart energy meter.

6. When using smart wifi energy meter for the first time, electricity should enter the main pipe slowly and the exhaust port should be opened at the same time to prevent residual air from pushing the meter impeller to run at an overspeed, causing damage to the impeller and affecting subsequent measurements.

During the installation and debugging process, if data needs to be transmitted immediately, contact the manufacturer's technical staff in a timely manner.