The General Classification Of Wedge-type Tension Clamps

1. dead end clamp for ab cable There are bolt-type tension clamps and wedge-type tension clamps; dead end clamp for abc cable It needs to bear the full tension of the lightning conductor or conductor. The gripping force of the clamp is not less than 90% of the rated tensile strength of the installed conductor or lightning conductor, but it does not act as a conductor. This type of clamp can be removed and used separately after the conductor is installed.

2. In addition to bearing the full tension of the conductor or lightning conductor, fungsi dead end clamp acts as a conductor. Once installed, this type of clamp cannot be removed again, so it is also called a dead wire clamp; because it is a conductor, the installation of the clamp must comply with the relevant operating procedures and be strictly implemented.

clamp dead end It is used to fix the conductor and bear the conductor tension, and it can also hang the conductor on the tension string group or pole tower. dead and clamp is mainly used for corner, splicing and terminal connection; the spiral aluminum-clad steel wire has good tensile strength and no concentrated stress, which can assist in vibration reduction and protection of the optical cable.