The Choice Of Power Fittings For Different Energy Systems Depends On Structural Differences.

The types of overhead power line hardware are not the same in photovoltaic power generation and wind power generation systems.

For photovoltaic systems, the commonly used types are connection type transmission line hardware and contact type electrical transmission line hardware fittings, which are used to connect wires and support structures. These hardware fittings for transmission lines types usually require good conductivity and stable contact to match the DC current output by the solar modules.

In wind power generation systems, due to the greater mechanical loads borne by the conductors and structures, suspension clamps, tension clamps, and aerial electrical fitting splices are often required. This type of power line hardware not only serves to fix the wires, but also has to withstand the tension and strain caused by wind pressure and vibration.