How To Adjust The Installation Position Of The Suspension Clamp

ab cable suspension clamp When tightening the conductor, place the conductor in the pulley to observe the sag. After the tightening is completed, the wire is hung on the corner and tension tower. After hanging, the conductor on the straight tower is still in the pulley. Before installing abc suspension clamp, the marking work of installation position adjustment must be carried out first. All markings must be completed in the same j hook suspension clamp before installing suspension clamp for ab cable to ensure that the stress of each gear is the same after the line is erected, and suspension clamp for abc cable to make the suspended insulation string in a vertical state, which meets the design and specification requirements.
suspension clamp for lt ab cable The adjustment of the installation position is to move the line length of the low stress gear to the high stress gear (pre-bias), generally to move the line to the upper gear on the mountain (pre-bias). The length adjustment center must be adjusted according to the calculated value LG. The starting point should be the intersection point O of the vertical line of the insulator string hanging point on the straight tower cross arm and the conductor. When LK is a positive value, it should be in the direction of the small side of the G tower (i.e., the G-1 base tower LG); conversely, when LG is a negative value, it should be in the direction of the large side of the G tower (i.e., the G+1 base tower LG). The end point is the center point of the installation clamp.