X-ray Inspection Of Tension Clamps

We all know that places with joints are the weakest places, and if bolted type strain clamp breaks, it will directly cause the wire to break. Therefore, the power grid company clearly requires: At the "three spans" (across the railway, across the highway, and across the important line), it is required to use X-rays to perform non-destructive testing on the compression pipe. X-ray detection principle: According to the different degrees of attenuation of the energy of the ray by the workpiece being inspected and the internal defective medium of dead end strain clamp, the intensity of the ray after passing through the workpiece is different, so that the bolted dead end clamp defect can be shown in the image. X-ray detection device composition: ① X-ray emission source ② Carbon fiber main frame Used to fix the equipment for easy detection. ③ X-ray box (imaging board) Convenient for imaging and improving detection sensitivity. ④ Receiving end Laptop and imaging software, usually completed in a few minutes.