What Specific Matters Should Be Paid Attention To When Using Wedge-type Tension Clamps For Conducting Electricity?

When fixed dead end clamp is used for current connection of wires, the crimping is tight and the connection joints are integrated. After crimping, the casing is fully and tightly covered with the wires, the current conduction is evenly distributed, the resistance is small, only micro-ohm level, the temperature is low and the tensile strength is large, which can reduce the failure rate by more than 80%. The line has stable and good contact performance, no maintenance, reduced maintenance costs, reduced energy consumption, and saved energy.
1. Contact performance: The contact surface between the wire clamp and the wire is large, the clamping force is large and constant, and the DC resistance ratio is between 0.85 and 0.9;
2. Overload capacity: The overload capacity reaches more than 2 times the rated current;
3. Firm performance: Bolt tightening or high-pressure crimping pliers are pressed and fixed, the connection is reliable and never falls off;
4. Thermal cycle performance: Good thermal cycle performance, always running below the DC resistance ratio of 1;
5. Installation: Easy to install and disassemble, suitable for high-altitude operations;
6. Energy-saving performance: The material is made of high-strength special materials, no electromagnetic loss, corrosion resistance, and oxidation resistance.