Blog

What Should I Pay Attention To When Installing The Power Fittings Ut Wire Clamp?

Publish Time: Author: Site Editor Visit: 59

aerial electrical fitting, clamp the stranded wire in the wire slot. It is generally used at the lower end of the cable tower. So what should be paid attention to when installing power line hardware? Remind you that you must pay attention to the following points when installing overhead line fittings:

1. Apply lubricant to the thread before installing distribution line hardware.

2. There should be no obvious loose strands in the bending part of the overhead line connectors cable. The cable break must be fixed reliably with the main cable. The length of the tail wire exposed at the wire clamp is three to five centimeters. The tail wire must be tied tightly with the main wire after turning back.

3. The tongue plate of the overhead line hardware cable clamp should be in close contact with the cable. There is no sliding phenomenon after being stressed. The convex belly of the cable clamp is on the side of the tail wire. Do not damage the strands during installation.

4. The overhead power line connectors cable binding wire should use a 3.2mm small galvanized iron wire. The long end of the binding wire is fifteen turns, the short end is five turns, and the tail wire of the binding wire should be twisted and tied tightly. The short end of the wire tie should be 25mm away from the offline tail, and the wire tie should be uniform and tight.

5. After the nut is put on, the length of the screw thread exposed should be one-third of the total length of the thread. After tightening, the double nuts of the UT type wire clamp are tight.

6. When the same group of wires in overhead power line hardware use double wire clamps and connecting plates, the direction of the tail wire ends should be unified.

What Should I Pay Attention To When Installing The Power Fittings Ut Wire Clamp?

Next Causes Of Deflection Of Suspension Insulator String