Blog

Standardized Installation Method Of Wedge-type Tension Clamp For Transmission Lines

Publish Time: Author: Site Editor Visit: 20

dead end clamp overhead line is usually used in the construction of overhead lines such as small-section aluminum stranded wire, copper stranded wire or steel core aluminum stranded wire.
dead end clamp with eye hook When installing, there are two common treatment methods dead end loop clamp: one is to wrap the wire with metal tape (the metal tape should be the same material as the wire), and the other is to line the dead end tension clamp wire trough and the pressure plate with gaskets during manufacturing. Note: When installing aluminum stranded wire and steel core aluminum stranded wire, it is necessary to wrap it with 1*10 aluminum tape.
Tool selection: fiber optic dead end clamp It is best to use a force measuring wrench during installation so that each fixed dead end clamp can be evenly stressed. At the same time, it is best to do it on the ground or on a special operating table as much as possible to ensure that the wire clamp has enough grip on the wire.

Standardized Installation Method Of Wedge-type Tension Clamp For Transmission Lines

Next Why Do New Energy Vehicles Use Pre-insulated Casing?