Selection Guide: Matching M-series Cable Glands To Ukk Splitter Box Outlet Ports
Matching M-series cable glands to a UKK splitter box requires aligning the panel knock-out inner diameter with metric thread pitch specifications (M16 through M40). Selecting the correct size ensures an IP68 seal, prevents wire strain, and guarantees safe current distribution across low-voltage power networks.
Box Models vs. Metric Threads
Correct physical dimensions prevent dynamic mechanical strain while preserving seal integrity on the terminal power block housing.
| Enclosure Model | Knock-Out Hole Size (mm) | Metric Gland Spec | Clamp Diameter (mm) |
|---|---|---|---|
| UKK-80A | 16.2 | M16 x 1.5 | 4 - 8 |
| UKK-125A | 20.4 | M20 x 1.5 | 6 - 12 |
| UKK-160A | 25.3 | M25 x 1.5 | 13 - 18 |
| UKK-250A | 32.5 | M32 x 1.5 | 18 - 25 |
| UKK-400A | 40.4 | M40 x 1.5 | 22 - 32 |
Technical Selection Steps
Follow this verified three-step workflow to select compliant fittings for industrial switchgear panels:
-
Step 1: Outer Sheath Measurement Measure cable outer diameter with calipers rather than relying on conductor cross-section data.
-
Step 2: Spacing Check Verify wrench clearance around the terminal power distribution block exit ports to prevent tool interference during assembly.
-
Step 3: Material Specification Select polyamide bodies for standard indoor panels, or nickel-plated brass with neoprene seals for corrosive, high-vibration settings.
Engineering Checklist for Ingress Protection
-
Thread pitch matches locknut torque requirements
-
Internal clamping claws feature anti-vibration strain relief
-
Sealing washers sit completely flat against enclosure walls
-
Cable jacket compression meets IP68 dust-tight standards
Pro Tip: Avoiding Common Assembly Issues
Installing mismatched fittings onto a UKK splitter box causes seal displacement, leading to moisture ingress and premature oxidation. Ensure locknuts align squarely against the enclosure wall to sustain uniform pressure across all output channels.
