How To Install A Smart Meter

1. Fix a 35mm standard track (its length can be determined according to needs) on the water meter to be installed;

2. Put the upper end of the bottom track groove of smart energy meter on the track, and then pull down the fastener of 3 phase smart meter. When the lower end of the track groove is on the track, loosen the fastener, and three phase smart meter will be on the track;

3. There are two situations for the installation of the electric energy meter: indoors and outdoors. Use fireproof and solid walls, which will not produce corrosive gases in the air and high-order harmonics;

4. Wiring the line according to the wiring diagram of the side cover of 3 phase wifi energy meter;

5. The voltage must be provided strictly according to the voltage level shown on the sign. If the voltage provided exceeds 1.5 times the rated voltage, the meter will be permanently damaged, even in a very short time.

6. When installing, be sure to fix the terminal well and fix single phase wifi energy meter on a solid, fireproof, and non-shaking screen. Since the downward viewpoint of 3 phase smart energy meter is better, it should be placed vertically, and the height should be about 1.8 meters.

7. After wiring is completed, seal the cover on the side of the instrument with a lead seal as required.