Analysis Of Factors Affecting The Measurement Of Power Fittings

1.aerial electrical fitting The insulation resistance will decrease with the increase of temperature. This is because too high temperature will aggravate the dielectricization of the resistor, which will then lead to increased conductivity and reduced resistance.

2. Moisture absorption on the surface of the insulation resistor or the formation of a water film on the surface of the porcelain insulation will also reduce the insulation resistance. In addition, when the relative humidity is high, the insulation resistor will absorb more moisture, which will also increase the conductivity and reduce the insulation resistance.

3. The insulation resistance measurement is equivalent to applying a DC voltage to the insulation, that is, charging the measured body. After the measurement, the measured body should be fully discharged and the discharge time should be greater than the charging time to avoid the charging current and absorption current obtained during repeated measurements being smaller than the previous measurement value due to the residual electricity not being fully discharged, thus creating the illusion that the absorption ratio is reduced and the insulation resistance value is increased.